Showing posts with label blu-tak. Show all posts
Showing posts with label blu-tak. Show all posts

Friday, 11 September 2009

Seeing more clearly

I had bought a set of magnifying glasses to help with the assembly/checking of the circuit boards. It suddenly occurred to me yesterday evening that I could perhaps try taking the photographs with the magnifying glass, since my camera really doesn't like very close-up work, despite having a close-up setting.

Tried it out this morning. Holding both items steady with the magnifying glass against the zoomed out camera lens, and trying to avoid casting one huge shadow over the subject was tricky, and I had to use Blu-Tak to hold the subject, but I am quite pleased with the results. I shall use this technique in future.
So here is the stepper motor driver board, again,



and then the strip of capacitors showing the opened end if you look really carefully (it is the invisiblest film - do you like the new word?), and then the front of the capacitors' packaging.


You can see the scale of this against the camera strap on the right of the photo'!

Friday, 4 September 2009

Testing 1, 2, 3, testing...

Before I went any further, I wanted to test the opto circuits I'd built, so I needed to know which pins were which on the RJ45 connector. I used this, which was the clearest description I found, with a nice easy diagram - so looking at the RJ45 jack socket on the board, with the board the right way up, the pin on the left is 1.
According to the circuit info. in the assembly instructions, pins 4 and 5 are connected together, and this is where the +ve end of my 5V power supply had to be connected, and pins 7 and 8 are connected together, GRND, and this is where the -ve end had to be connected.

Below is a photograph of my testing set-up, using 3 D cells (giving approx. 4.5V) and some alarm wire all blu-tacked together. It took some fiddling to get continuity; too much blu-tak insulated the alarm wire strands!



I stood the battery-tower up and wedged it inside a perfectly-sized cardboard box to hold it all together better. Here is a photo' of the circuit board with its optical sensor blocked with some folded corrugated card (the wire in the foreground is not actually making contact yet) , and below that a photo' with the LED lit.




Believe me, holding the wires to get this working whilst taking a clear photo' was no mean feat!
Hoorah! All 3 circuits work as hoped, with the LED lighting when the sensor is blocked, and going off when unblocked. I am delighted! My first ever soldering was a success!